0
Front and rear spring rate and size for stock suspension on Datsun 1600 510?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the spring rate in PSI for the stock suspension springs on a Datsun 240Z?
The calculated rate in pounds per inch for the stock front springs on a 1971 240z is ~100 lb/in. The data used was from direct measurement as follows: 8 active coils 0.437 inch coil diameter 4.447 inches spring outside diameter torsion modulus (G) 11.5 x 10E06 psi
What is the stock tires size on a 1972 Datsun PL521?
The stock tire size is 195/75/14.
What is stock tire size for 1979 Datsun 620?
215/50R15
What size motor is stock for a 71 Datsun 240z?
2.4L or 2,393 cc
What should be done when a 97 Firebird sits too low in the front with an all stock suspension with new struts?
Springs, not struts set the height.
How much lower is the front coil springs on a Chevy extreme compared to a stock s10?
the spring height is 1.25 in. shorter but the spring rate is different and the leaf springs are also different.
Where is the cold air intake in Pontiac Grand Am?
It isn't a stock intake but your intake will be sitting on the drivers side in a black plastic box just in front of your suspension mounting.
How fast will a stock Datsun 240z go?
125mph (top speed) 0-60, 8.0 seconds (acceleration)
How do you remove the forend stock from a Stevens 315 SXS shotgun?
You grasp the forend at the front tip and pry it off. It is held in place by spring tension.
Will stock Rubicon suspension lift my wrangler SE?
Possibly The SE coils and Rubicon Coils are the same length but the Rubi coils have a stiffer spring rate and you could gain 0 to 2 inches of lift if your springs are sagging
Will 20''rims fit a Ford Probe?
yes, however you wont be able to turn very far. as long as your car has stock suspension or higher suspension. i would stick to 19" and smaller. yes, however you wont be able to turn very far. as long as your car has stock suspension or higher suspension. i would stick to 19" and smaller.
Will disc brakes and spindles from 74 Chevelle or camaro fit a 72 Chevelle are any mods needed?
They will NOT fit without a considerable amount of modification to the front suspension. The calipers and rotors will probably work with spindles from a '68-'72 GM A body, but the spindles won't work with the stock suspension.
