The fuse for the brake light on a Hyundai Accent are found in the engine compartment. The fuse is number four in the fuse box, and is rated on 10 amps.
Brake light switch, goto your Hyundai dealership, buy the part for $15 and install it
it would be the brake light switch about 20 dollars at autozone
There should be a fuse for the brake lights. If the fuse is good always check the ground wire.
Fuse 7 controls the brake lights. It should be a red 10amp fuse.
what number fuse is for the brake lights on a 99 vw passat what number fuse is for the brake lights on a 99 vw passat
Chjeck the brake light switch located somewhere on the brake pedal lever.
should be the tail lights fuse
Yes there is a fuse for your brake lights. Check your fuse box. It should be marked. If the fuse is ok then check the switch. It could be a bad switch or ground.
Brake light fuse
What fuse is for the 2005 Ford mustang Rear Brake lights?
What fuse controls the brake lights on a 1998 Chevy Camaro? It should be labeled on the fuse block.
if you 3rd brake light still works it is most likely a fuse. If none of your lights work usually it is the brake light switch located on the top of the brake pedal. Although there could be some odd wiring issue. Chances are it is the switch.
I have a 2002 Hyundai accent and my headlight are out but all other light are on, also light is glovebox is out. Is there a fuse for this?
Where's the fuse situated for brake lights on a Peugeot partner 1998
It is not necessarily the fuse. It could be the switch on the brake that is not closing the circuit.
project on autobiles
One fuse controls the function of the hazard, reverse, and turn signals of the car. When there fuse blows all the components stop working.
On the fuse box under the hood it shows STOP and HORN that should be for the brake lights
Tail lights and brake lights fuse.
Tail lights are usually on the same fuse with interior lights and dash lights. That is so you will know when the fuse is blown. Brake lights are usually on a different circuit. If a fuse is blown, try to figure out the cause rather than just replacing the fuse.
If there is no brake lights on a 1998 Mazda pickup, check the fuse. If the fuse has blown, the lights will not work.
It is under the hood fuse box, it has written everything outside.
My local mechanic was able to get me a full fuse layout blueprint.
In the front fuse Box near the Air filter
Running lights (left side): Fuse #47 -- Running lights (right side): Fuse #48 -- Brake lights: Fuse #54. Fuse panel is on the lower left side (underneath) the dashboard. NOTE: If it is your brake lights that are not working and fuse # 54 looks okay, check the brake light switch, it may have gone bad.