It is called the Timing Chain Cover. It is the same for most 289s and 302s.
I think it's depending on the vehicle, there may be a spacer between the starter and the motor. There may be a shield between the starter and the transmission housing if your starter is bolted to the transmission.
Is there a spacer on the top of the water pump between the A/C and the pump
on my sabo mower the blades rattling is there some kind of spacer i need thanks
there should be a thin guard usually stainless steel that fits over the guides for lining up the tranny. between engine and transmission.
starter motor is mounted into the front of the bell housing this is also where the bolts to secure the starter go if there is a plate between starter and bell housing, it is a spacer to give correct clearance of starter gear and ring gear teeth
We put Billet pulleys and Throttle body spacer on mine & I noticed a HUGE difference in performance. Also, we are going to put headers on it. I noticed about a 35 - 40% difference with just the spacer and pulleys.
the magnets in motor were backwards alls good thanks for the help
The junction between a motor neruon's axon and the muscle cell membrane is called a neuromuscular junction or a myoneuraljunction?
Some applications use a spacer between the engine and transmission to give proper clearance in a situation where an existing transmission is mated with an engine that it may not have been designed for. I don't know of any plates on the motor mounts so im guessing that's the one that you are asking about.
check you motor mounts and trans alignment your pulley shouldn't wobble with a new assembly
it might be called a axon It is called a motor end plate.
remove the battery and the cpu, the blower motor will be right under it.