There are some screws on the reverse or the wheel. Start here :)
They are bolts (10mm I think) that you unscrew the 4 and remove the airbag. Undo the 2 electrical connections (orange one first) and put the airbag dowwn. Then unscrew the nut holding the wheel onto the spline/column. The wheel may need a firm wiggle to release it.
The flasher unit on a Mazda 323 is located on the end of the flasher lever. Remove the lower steering column to bring the unit to view.
how do remove the brake drum on a 1991 mazda 323
NO, but the entire wheel assembly will have to be removed.
mine doesnt
?
Under the bonnet. :-)
replace headlight on mazda sp20
High Positive Offset +35 to +45
you may want to try this: - remove the center cover (horn switch)(im not so familiar the names of the parts) of your steering wheel by removing the screws underneath. - remove the steering wheel. You may use your cross tire wrench to remove the nut that holds the steering wheel. pull-off the steering wheel. - unscrew the plastic covers of the steering rod/tube. - disconnect the snap-in connection of the electrical wirings of the ignition switch - unscrew the holder (metal belt) of the ignition barrel. - an ordinary locksmith can fix your ignition switch.
With an uncle and a hammer.
There are 4 bolts behind the airbag housing that you undo in order to remove the airbag. Once you have removed these support the airbag and unclip (orange clip first) the orange and blue connectors and place the airbag to one side. You can then undo the nut that holds the wheel on the spline, give the wheel a firm wiggle/tap from the back and it will release. If you want to alter the angle then do so and refit or if to completely remove unclip the electrical connector and pass through the space hole. Rgds. Terry
Agents recommend 185nm. We do 200nm.