Is made by snap on and is usually a john bean balancer with FMC name on it
you need a wheel balancer for that
You will need to go through the passenger front wheel well (wheel off). Remove belt, remove pulley/balancer with a balancer puller tool. Air tools make this job MUCH easier.
when i calibrate my FMC wheel balancer i only get cal o not cal good at the end
Hunter wheel balancer parts can be found by doing a simple key word search of the specific balancer online. You may also be able to find a second hand dealer locally that caters to mechanics needing parts and sells parts wholesale.
Not that I've heard. I'm sure the would edit it out as the show is not live
Call 502 5538210 we have a spare transformer for 190.00
It is low of Liguified petroleum gas, top it up
We Heard You was the Wheel of Fortune Bonus Puzzle for December 28 2012We Heard You was the Wheel of Fortune Bonus Puzzle for December 28 2012We Heard You was the Wheel of Fortune Bonus Puzzle for December 28 2012We Heard You was the Wheel of Fortune Bonus Puzzle for December 28 2012
If your refuring to the harmonic balancer use a good steering wheel puller!!!!
C series is 2-wheel drive, k series is 4-wheel drive.
Wheel balancing machines can run from $700 - $1,000 and up. There is no wheel balancing kit, but most tire shops will use their machine to balance your wheels at a fairly low cost.
Remove the right front wheel and inside fender skirt. Remove the serpentine belt. Remove the bolt at the center of the balancer. If a 3.8L engine, use special tool to pull balancer off, otherwise use hands to pull it off, wiggling as necessary.