You will need to go through the passenger front wheel well (wheel off). Remove belt, remove pulley/balancer with a balancer puller tool. Air tools make this job MUCH easier.
at the front of the engine,next to the harmonic balancer
You will need special tools like: harmonic balancer puller, and impact wrench.
You need a harmonic balancer puller, and a 1/2 in drive inpact wrench.
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
sounds like the rubber damper is worn on the harmonic balancer. if this is the case you will have to replace the harmonic balancer.
Actually, you don't replace the sensor itself. The crazy thing is part of the harmonic balancer, and you have to replace the whole thing.
it is behind the harmonic balancer.
no it;s behind the harmonic balancer take off passenger right front tire and you can get at it. you will need a wheel puller to pull the harmonic balancer off
Behind the harmonic balancer.
take off your harmonic balancer the answer is behind
About 200 foot pounds.
sounds like you broke the crank sensor that is mounted right behind the balancer.
It's just behind the harmonic balancer.
its behind the harmonic balancer attached by two bolts but you must first take off the balancer to get to it
It is located behind the harmonic balancer on the front of the engine. You'll need a special puller to remove the balancer.
YOUR LOCAL AUTOPARTS STORE WILL RENT YOU A PULLER AND SHOW YOU HOW TO USE IT.
The bolt is stuck and can't seem to come off.
I tried to change the harmonic balancer of my biuck lesabre 1994, but i can't remove the old one, the bold in the center is very , very tight and i don't know the type of screw, right or left turn.
If you meant harmonic balancer keeps going bad you probably have a bent pulley.
its right behind the harmonic balancer....so you will have to remove the h.b them remove the crank sensor...
140-160 ft lbs
Remove belt, balancer bolt and get a balancer puller to remove the balancer. Unbolt and unplug sensor to replace it. An air impact wrench that is strong will get the bolt loose.
the crankshaft sensor is located behind the harmonic balancer on the ft timing cover
The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.