sounds like you broke the crank sensor that is mounted right behind the balancer.
About 200 foot pounds.
take off your harmonic balancer the answer is behind
You need a harmonic balancer puller, and a 1/2 in drive inpact wrench.
its right behind the harmonic balancer....so you will have to remove the h.b them remove the crank sensor...
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
no it;s behind the harmonic balancer take off passenger right front tire and you can get at it. you will need a wheel puller to pull the harmonic balancer off
Yes, all cars do. It is the crankshaft pulley assembly...the biggest pulley, typically, at the very bottom of the engine.
the crankshaft position sensor is located right behind the harmonic balancer mounted on the timing cover
it is behind the harmonic balancer.
Behind the harmonic balancer.
I believe that is the harmonic balancer. If that has failed, you will get engine vibrations at the lower speeds. It should be replaced.
yes