0
Where is the crankshaft sensor on a 1989 Buick Regal 2.8 V6 and how do you replace it?
Wiki User
∙ 12y ago
at the front of the engine,next to the harmonic balancer
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you remove a Crankshaft Position Sensor?
how to remove crankshaft position sensor from 91 Buick Regal
Where is the crankshaft position sensor located on a 92 Buick Regal 3.1 V6?
The crankshaft position sensor, on your 1992 Buick regal 3.1 liter, is located on the back of the engine. The crankshaft position sensor is on the inside of the engine cover.
Where is the crankshaft sensor on your 99 buick regal?
Behind the crank pulley
Where is the Crankshaft sensor on a 2000 lesabre?
The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.
Where is the crankshaft sensor on 1995 buick regal 3.8l and how do you change it?
The crankshaft sensor is located behind the harmonic balacer. you will need a puller with special bolts to remove the balancer.
Why does your 1988 Buick Regal not start when you try to crank it after it has been running?
if it has a crankshaft sensor that's bad
Where is crankshaft position sensor located on a 1994 Buick Regal 3.8 and how do you replace it?
behind the crank shaft pulley. remove pulley and install new one make sure to replace it in the exact same spot it was before of you will tear up your new sensor
MAP sensor on 2001 Buick Regal LS?
Where is the map sensor on a 2001 Buick Regal Ls
Where is the knock sensor on a 1992 Buick Regal 3800?
Where is the knock sensor located on a 1992 buick regal
How do you fix a buick regal 1996 that has no spark the fuel pump and filter and ignition control system are new?
It sounds like you need to replace the crankshaft position sensor! If it is bad you will not get any spark.
Where is the headlight sensor for a 1999 Buick regal?
Where is the headlight sensor for a 1999 buick regal? Its in the back, sike ;D
How do you replace cam sensor on buick regal 3.8L?
In order to replace the cam sensor on a Buick Regal 3.8L, you must first access the main dash board from the back by either entering the hood or removing the panel, and then crossing the two wires in question.
