0
I would suspect a vacuum leak. If the car is over 10 years old, I would recommend you replace all vacuum hoses under the hood. Do them one at a time as to not get confused.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Why does my Chevy Venture overheat when idling but is fine when driving?
Check coolant level Cooling fan working? Dirt or clogged radiator? Defective radiator cap?
What causes rough idling on a 2001 Chevy Tahoe?
I would suspect the idle speed motor is faulty. Does the motor sometimes idle fine and then other times rough? They are about $100.00 last time I had priced one. Your dealer can price one and print out a picture of it and where it is located so you can recognize it.....1930fcoupe
Why does my car jerk and act like it's going to choke out while idling in drive but runs fine in park or neutral?
change left side windo
What trans oil is in a 1998 Chevy S-10 pickup 5 speed manual?
Mercon works fine.
What type fluid in a 1998 Chevy S 10 5 Speed Manual Tranny?
Mercon works fine.
How do I fix a screeching noise in my 2011 dodge ram pickup?
I have a screeching sound in my pick up when it gets up to 2000 rpms. Does not make the noise while idling and starts fine.
Will Chevy 305 heads fit on a Chevy 327?
Yes, they should bolt on just fine. Might get a little more low-speed torque with a decrease in top-end horsepower.
What would make a 1992 Honda Prelude SI 2.3 surge while idling in park but idle fine in gear?
Hi I had this problem. make sure your water level in the radiator is full,because there is a sensor kelvin
Why would a 1989 Olds Cutlass Calais sometimes die while idling and get gas surges when going slow?
i had this same problem with my 85 and about 3 months later my fuel pump went out changed it, workds fine now
Will a Chevy 350 bolt up to a ford 4 speed transmission that fits a 300 in line 6?
You would need to purchase the correct bellhousing, then it should work out fine.
Suburban running fine then will suddenly slow to zero will not increase speed when given gas Coast for a short distance then dies Takes about 3 tries then cranks and runs fine for a while?
transmission
Why is the cutlass stalling when idling but rides fine when you hit the gas?
Is it carburated? If so I'd check that out, might need to be retuned or something.
