you should try checking the fuses and replacing the bulbs the fuses for thos lights should only be about a 10 or a 15
Bad bulbs? Sockets corroded?
If the turn signals on a car works but the hazard lights do not there may be a problem with the flasher switch. The flasher is located in the steering column, and a damaged unit can cause the lights to stop working.
Turn signal relay needs to be replaced. If you turn on the hazard (emergency) switch, all the signal lights should come on. This says the lights are okay.
Stop signs
four-way stop
Hazard switch is the signal relay has gone bad. Defective from new, has been replaced with a different part number.
You may have blown a fuse or a flasher.
It could be a couple of things. On some vehicles, if one of the bulbs burn out in the taillight or turn signal circuit, both will stop working, but only on that side of the car. Some cars also have the brake lights wired through the hazard flasher, which if malfunctioning, can cause problems for both circuits, on both sides of the car.
first make sure hazard lights are not on.next you need to ckeck the grounds from the battery.
Try replacing the turn signal flasher
When approaching the Zebra Crossing you have to reduce speed, put your hazard lights, signal your intensions to stop. Then take off when the pedestrians have crossed
Check bulbs Check sockets for corrosion Check sockets for power and ground Check fuse for stop lights Check fuse for parking/tail lights