From:
http://www.autozone.com/autozone/repairinfo/specifications/specificationsMain
1993 Pontiac Lemans-Import 1.6L TBI SOHC 4cyl
Application:
Cylinder head bolt torque sequence
Note :
Torque sequence ----------------
| 8 4 1 5 9 |
| 7 3 2 6 10 |
----------------
Step 1: Torque in sequence 18 Ft/Lbs
Step 2: Torque in sequence 60 degrees
Step 3: Torque in sequence an additional 60 degrees
Step 4: Torque in sequence 30 degrees
recheck final torque in sequence
>*** CAUTION *** <
Engine uses Torque To Yield head bolts (TTY) that
permanently stretch during the initial installation.
New head bolts must be used when cylinder head is
replaced or re-installed to obtain proper torque.
-------------------------------------------------------------------------
Just in case you need this info too:
INTAKE [Manifold] BOLT TORQUE1993 Pontiac Lemans-Import 1.6L TBI SOHC 4cyl16 Foot pounds (Final torque)Note: to torque bolts & nuts, start in center using crisscross pattern working outward
--------------------------------------------------------------------------
Hope this helps. :-)
A 1993 Pontiac Sunbird head bolt torque sequence recommends starting at one and of the head and alternating to the other end of the head. You should end up in the middle.
in a shop!
why did my timing belt break on my pontiac 1.6 1993 motor also will the valves be bent because of that
the ignition module is under the distibutor cap
right hand shroud and the data link is right there too hope this helps
petrol/deisel 2.4 or 3.0??
i don't now
170 horsepower with 225 foot pounds of torque
17 pounds
Try replacing the gauge cluster. 93' LeMans should cost you $15-20 at a wrecking yard.
go to your garage and make a battery and charge test, probably a charging problem
i have a 1990 lemans and it is located under my back seat you flip up the seat bottom and there is a flap of carpet there it may be the same on yours