Up behind glovebox on passenger side held in with 3 screws.
Remove the wiring harness from the back of your 1996 Chevrolet blower motor. Remove the blower motor retaining bolts. Remove the fan from the blower motor. Reverse the process to install your new blower motor.
check fuse
Try looking under the passenger side foot area. The blower motor will be there, and the blower motor resistor should be there also, will have a wiring harness and I believe 2 bolts holding it.
I have changed 2 blower motors and one fan relay in my 96 s-10 in 230,000 mi.
This model has a common failure with the fan motor connector. Check wjjeeps.com for pictures and a home made solution.
To change the heater fan on a 1996 Jeep Grand Cherokee, first disconnect the negative battery cable to ensure safety. Remove the passenger side lower dash panel to access the blower motor. Disconnect the electrical connector and unbolt the blower motor from its housing. Replace it with a new fan, reconnect the wiring, and reassemble the dash panel before reconnecting the battery.
I mean how do you disassemble the fan blower in a 1998 Jeep Grand Cherokee Laredo. how do you remove the blower fan from the car in the Grand Jeep Cherokee Laredo.
there are two on the right hand side of the engine bay. top corner.
blower motor resistor is bad
check the blower fuse if the fuse is good the blower motor is bad or else you have short
Behind pass. side head light there are 5 relays.A/C relay is the 2nd from the right,looking down from front of car.Drivers side to pass. or right to left.#1)fuel pump.2)A/C.3)heater/A/C blower fan.4)eng.puller fan.5)eng.pusher fan.
Under the dash, at the extreme right near the passenger kick panel.