Car Fuses and Wiring
Heater Cores and Blower Fans
GMC Jimmy
Toyota 4Runner

Heater fan for 1997 blazer will not run new fuse has been put in fuse box still not working?

Top Answer
User Avatar
Wiki User
Answered 2007-01-25 16:11:54

Also Check the Switch it could be bad. Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For more information. Check fan motor and wires. If the fan is not running, then it is either a blown fuse, defective blower motor speed control switch, bad blower motor resistor pack, or a defective blower motor. If the fuse is good, the odds are the Resistor Pack is bad.

User Avatar

Your Answer


Still have questions?

Related Questions

Replace heater core in 1997 Chevy blazer?

how to replace a heater core in a 1997 Chevy blazer

How do you remove the heater fan on a 1997 Chevrolet blazer?

were is the heater relay on1996 jimmy?

Where is the location of the heater motor in 1997 Chevy blazer?

Same as a 96 blazer go here.How_do_you_replace_the_blower_motor_on_a_1996_Chevy_blazer

Where is the heater core located on a 1997 Chevy Blazer?

Behind the dash assembly, big job for the faint at heart.

Why do i get a Water swishing sound when you accelerate 1997 blazer?

your heater core is going out, you need to replace it before it ruptures.

What could be wrong is a 1997 Chevrolet Blazer when there is little heat blowing?

Thermostat stuck open, clogged heater core, heater flow valve not functioning, or low of coolant.

1997 s10 blazer change heater coil?

To many steps to list here, would recomend purchasing a shop manual if you intend on replacing that heater core yourself.

My 1997 Ford Probe GT's heater stopped working?

Check the thermostat, also there could be a heater core issue...

Why would a 1997 s10 Blazer heater only work on occasion?

It can be that your coolant level is low, your thermostat is stuck, the actuators are sticking...

1997 Chevrolet blazer overheating?

why is my 1997 chev blazer over heating

What other years blazer parts are interchangeable with a 1997 Chevy blazer?


1997 blazer can a buick steering column be used in a blazer?


Will a 1997 Chevy blazer work on a 1999 Chevy blazer?

Will a 1997 blazer what work on a 1999 blazer????? If your talking engine, transmission, or running gear than yes. It is all the same.

Will a 1997 blazer CD radio fit in a 1996 blazer?


How do you change cabin air filter on 1997 Chevy blazer?

The 1997 Chevrolet Blazer didn't come with a cabin filter.

Temp gauge not working trying to locate sensor location in 1997 Mazda b2300?

Try heater hoses.

Would an automatic transmission from a 1997 Blazer fit a 1996 Blazer?


Why will your heater blow but will not heaton a 1997 ford tourus?

Low coolant? Thermostat not opening? Heater core restricted or plugged? Heater core airbound? Water pump not circulating coolant? Temperature control not working?

Does a 1997 Chevy blazer have a timing belt or chain?

The 4.3 liter V6 engine in a 1997 Chevy Blazer has a timing CHAIN

The heater in your 1997 ford contour stopped working how can you tell if it's the heater motor or the fuse you could smell melting plastic when it stopped working?

sounds to me like your blowe moter is shorted out. u can use a test light to check for power at the motor,if you can also pull fuse out of fuse box to check fues BUT the blower motor will notstop heater working if no heat ,it is your heater core

How do you get to the heater core in a 1997 Chevy Blazer?

DON"T TRY IT! I'm 5 hrs. into it and haven't got the dash off yet! Replacing the engine is eaiser! Steve

How do you change the shocks on a 1997 Chevy Blazer?

a 4 door 97 blazer front how do i do it

Location of resister for blower motor on 1997 s 10 blazer?

location of resister for blower motor on 1997 s 10 blazer

How do you replace the heater core on e150 1997?

How do i change the heater core on a 1997 ford e150

Heater core 1997 s10 blazer?

Not a fun job. If your looking to replace the heater core it requires removal of the entire dash and steering columm. I would suggest purchasing a shop manual for that vehicle to help you step by step thru the job.