Honda Accord

Help Locating and trouble shooting Ignition output signal on 94 hounda accord?

363738

Top Answer
User Avatar
Wiki User
Answered
2006-03-20 15:28:55
2006-03-20 15:28:55

For a few years there, Honda had a problem with the ICM. It's inside the distributor.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


how to put in a ignition on a Honda accord 1991

how to change manual ignition switch on a 93 Honda accord

Lost ignition keys for newer vehicles can be obtained from the vehicle dealership. Lost keys for a 1978 Honda Accord will require the replacement of the ignition.

The 1993 Honda accord ignition actuator can be found beneath the dashboard. The actuator will be on the drivers side of the passenger compartment.

no because a 1991 accord comes whith a ignition coil inside of the distributor end 1993 the ignition coil is outside end the holes dont line up

A person would have to do simple trouble shooting on the horn. There are only a few things it could be the fuse a break in the wiring or a fuse a person with basic knowledge could trouble shoot this in a matter of an hour.

Where is the elctrical part behind the igtion at on my 1992 honda accord

no the switch can be independly remove from the back side of the ignition lock

A Ignition coil diagram for 1991 2.2 Honda accord

The ignition fuse box in a 2006 Honda Accord Coupe is located on the right side of the engine compartment. It is seal inside a water tight box to prevent damage.

bad cap or rotor . ignition coil , or ignition mudgule or new or rebilt distributor

The Ignition Control Module on the 4 cyl models is located under the Distributor cap.

my ignition on my Honda accord will not turn over all of a sudden.could this have something to do with the viper alarm? thanks

Turn the ignition switch clockwise until it starts, then release.

If you are having the same issues (starting problems-no spark) that I had in my 1991 accord, I found out that there appearantly was a recall on the distributor. Do not try to replace pieces and parts of the ignition system. (ie. coil, ignition control module, etc.) Replace the entire distributor. It will save you hours of frustration.

How do you fix trouble code po1362 and the Honda odssey 2000

It is telling you that you have left the keys in the ignition.

trouble code P0009 means: Engine Position System Performance - Bank 2

Trouble code P0117 means:Engine coolant temperature circuit low input

Could be a bad ignition switch

i would check all fuses and the ignition switch

It usually make a tick sound when you turn the ignition.

Go to Auto Zone's web site and type in Engine Trouble Code. They have a list for your vehicle and explains how to.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.