The highest priority interrupt in a microprocessor is usually the reset interrupt. When a reset occurs, the microprocessor is forced to stop its current operations and begin executing the reset routine. This is critical for initializing the processor and setting it to a known state before starting normal operations.
WordStar is often considered the first widely used word processor for microcomputers. It was released in the late 1970s and became popular among users of early personal computers.
Microoperations are fundamental operations that can be performed by a digital computer's control unit at a very basic level, usually involving simple data manipulation or transfer tasks. These operations form the building blocks for more complex instructions and tasks executed by a computer's central processing unit (CPU). They are essential for controlling the flow of data and instructions within a computer's architecture.
One main limitation of micro teaching is that it may not fully simulate the complexities and challenges of real classroom teaching, such as managing behavior issues or addressing varying student needs. Additionally, there may be limitations in the transferability of skills learned in micro teaching to actual teaching situations.
Micro teaching allows teachers to practice and receive feedback on specific teaching skills in a controlled environment. It helps teachers refine their instructional techniques, improve lesson delivery, and build confidence in their abilities. Additionally, micro teaching can promote reflection and lead to more effective teaching practices in the classroom.
The micro level in curriculum development refers to the specific details and components of the curriculum, such as individual lessons, learning activities, and assessments. It involves the alignment of instructional materials, teaching strategies, and assessments to meet the goals and objectives of the curriculum. At the micro level, educators focus on the day-to-day implementation of the curriculum to ensure effective teaching and learning.
It is an interrupt having highest priority in 8085
The INTA- (Interrupt Acknowledge) pin on the 8085 is an acknowledge of the INTR (Interrupt Request). It has the same timing as RD-, and external hardware is expected to provide an opcode, usually a CALL or an RST instruction, in response to INTA-.
what is name of latest micro processor in computer hardware in india
Bus ArbitrationIn a single bus architecture when more than one device requests the bus, a controller called bus arbiter decides who gets the bus, this is called the bus arbitration. Arbitration is mostly done in favor of a master micro processor with the highest priority.
micro controller contain system on chip memory, timers,counters where as a micro processor doesn't contain all these
It is a routine in a micro controllers program where the program jumps to after receiving a interrupt on the micro's interrupt pin. Because most micro's can only run one programme at a time, one need a way for the micro to stop doing what it's busy with, to service an outside peripheral that need urgent attention. For instance the micro is running a flashing LED, a push button that one want to use to stop the flashing and start to flash another LED is connected to the interrupt pin of the micro then the program save what it was busy with on a stag and immediately start the interrupt routine.
Because the printed circuits are so small that you need a microscope to see them.
Ram
4
no answer
Gary Boone
Micro-Processor programming model refers to the Micro-Processor system as seen by a programmer. It involves the following: The Instruction Set - The Micro-Processor internal Registers - The way Micro-Processor accesses the memory (Addressing - Mode): Micro-Processor 'Fetches' (reads) an instruction from memory, 'Decodes' (interprets) the instruction, and then 'Executes' (carries out the task) the instruction. It repeats the cycle for next instruction. By Fijabi Isaac M. Tech Computer Sc.