answersLogoWhite

0

If it is just the plastic handle broken, behind that is the cable that opens the hood. Just grab the cable with a pair of pliers and pull. You can probably just replace the inside handle and not have to run a new cable.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do i open the hood on a 2000 beetle if the hood release lever is broken inside the car?

To open the hood on the 2000 Beetle if the hood release lever is broken inside the car, you can remove the glove compartment of the vehicle and find the release cable inside the dashboard. Pull the cable to open the hood. You will then need to replace the hood release lever.?æ


How do you replace a broken parking brake release lever on a 91 Jeep?

I believe tyhere was a recall on this. check with dealer


How do you open hood Toyota Avensis when the release lever inside is broken?

Next to impossible. A new release lever will need to be installed. Take it to the Toyota dealer ... they built it, they know how to repair it.


How do you fix a broken seat back lever on a 2003 Pontiac Montana?

Replace the lever with a new or good used one.


How do you release the emergency brake on a Chevy Suburban when the emergency brake release lever is broken?

There is a small metal lever back by where the foot lever rotates (normally the release cable is hooked into it) Pull it forward and the foot lever will release - careful it doesn't smack you in the face!


How can you open hood from outside if inside release lever came disconnected on a 1995 Chrysler LeBaron convertible gtc?

You can open a hood on a 1995 Chrysler LeBaron convertible gtc from the outside if your lever is broken. All you have to do is get a pair of vise grips and pull the cable which will release the hood.


How do you remove and replace levers on a dirt bike?

Remove the bolt in the lever perch. For a clutch lever, loosen the cable enough to remove the broken lever and replace the new one. Adjust the clutch cable back and replace the bolt in perch. For the brake (disc brake)) lever, you simply remove the bolt and replace lever, put the bolt back in the perch and you're done. If you have drum brakes, it is the same as the clutch lever routine.


How do you fix a diverter spout lever that broke off?

Depending where is has broken off, depends to what extent of how much you will have to replace, but worse case scenario is, inside there is a cartridge that has a little lever that the diverter handle attaches too. This whole cartridge needs to be replaced. Depending on the make, it can be costly.


How can you release the e brake when the cable is broken on a 1993 Dodge Dakota?

Its very easy. You can look by the brake pedal and there is a release lever with a hole in it. just pull the lever towards you and it will release.


Why won't Gas cap won't open when you pull lever inside car?

Probably a broken cable.


How do you replace the open bonnet lever in fiat bravo?

To replace the open bonnet lever in a Fiat Bravo, first, locate the lever inside the vehicle, typically near the driver's side footwell. Remove the cover or trim panel if necessary, then detach the old lever by unfastening any screws or clips. Install the new lever by securing it in place, ensuring it connects properly to the release mechanism, and reattach any panels. Finally, test the lever to ensure it operates smoothly.


Where is the location of the fuse for the towhaul switch in my 2003 Silverado 1500hd?

it is not the fuse it is a broken wire. Replace the shift lever.