answersLogoWhite

0


Best Answer

Broken Or Disconnected Wire To The Horn. Check For Voltage When Horn Button Is Pushed At The Wire After Removing It From The Horn. On A Vet Probably Not Grounded.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Horn will not work on your 1991 corvette what else could it be besides the relay or horn button?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What other parts besides the headlight motor can cause intermittent failure of 1985 corvette headlight Is there a relay switch?

== ==


Where is antenna relay location on a 1989 Corvette convertable?

where is the radio antenna relay located in a 1989 Corvette Convertible


Why does Horn on 1998 corvette convertible intermittently work?

The reason for the problems with the horn on the Corvette could be attributed to a faulty fuse or horn relay. This can be located in the fuse and relay box that is located under a panel on the passenger side floor board.


Where is the horn relay located in a 1995 corvette?

The 1995 Chevrolet Corvette on relay switch can be found in the fuse box. The horn relay switch will be in the third column, second from the top.


Where is the fuel pump relay on a 1990 Corvette?

== ==


Where is the power antenna relay on a 1979 corvette?

== ==


Where is the starter relay on a 1995 Corvette?

why is there no answer to this yet...


Is there a horn relay on a 1972 Corvette?

Yes sir there is s small horn relay on a 1972 Corvette. 1. I am a racing instructor 2. I own this car!


Where is the blinker relay located on a 1977 Corvette?

It doesn't have a relay but a flasher under the dash.


Where is the turn signal relay on a 1990 Chevy Corvette?

== ==


Where is the fan relay located on a 94 Corvette?

The 1994 Chevrolet Corvette fan relay switch is located in the fuse box. The fuse box can be located in the engine compartment.


Why would a car horn be blowing on its own on a ford 1998 windstar minivan?

The horn button or relay could be stuck. The most common cause is the relay sticking closed, as opposed to the button.