A 366 big block Chevy usually had between 220 - 262 hp and the torque usually ran between 450-510 they were a very low end torque engine they were built for nothing else but pulling they were put into medium duty truck usually from 2 ton to 3 ton trucks. They are a tall deck engine with a small combustion chamber and small valves for a big block but very high output at low rpms. They had a bore of 3.935 and had a stroke of 3.760 they used three compression rings. One of the major flaws of the 366 was that when you would down shift pulling heavy loads up a steep grade the heat in the combustion chamber would burn holes threw the valves because of high out put but now were for it to go.
460 horsepower
150 horsepower
Clockwise.
.017.
First of all is that a 350 is not a big block. It is a small block.
A lot!
There are several horsepower options for 366 cubic inch General Motors engine. The largest General Motors horsepower option was 420 horsepower.
first off a 350 is not a big block, its a small block, and its 195 bhp.
250 hp
No the 350 has always been a small block. The smallest big block made by Chevrolet was the 366 truck engine and the 396 car engine.
where is oil sending unit located on a 366 gasoline engine on 1995 gmc topkick
6 degrees advanced, or BTDC.