Follow your main wire harness that comes from your engine that goes through the firewall, there is a big rubber seal that seals the hole. You will have to poke a hole through that rubber seal. That is the easiest way, otherwise you will have to use a drill and drill a hole big enough to fit your wire.
Get a multimeter and put it on the ohm setting. Touch the wire with one probe and the engine block with the other lead, if the meter reads anything but OL, it's shorted to ground.
Live wire and the neutral wire
i do believe that you do put the yellow wire from the wwall thermopstat marked yellow for air to be colder,
put a wire through it
You need to splice the extension Romex, using wire nuts, inside a covered junction box made for the purpose. If you can do it within the original outlet box you can put a blank cover on the box. If not you may have to install a new "old work" box in wall. If you can get to wire in attic or basement you could put the junction box in one of those locations. The junction box must be accessible so you can't bury it in the wall.
In 2004 Chevy moved the fuel filter from the drivers side frame rail and put it inside of the FUEL TANK.
Put the wire back.
put in a vette engine lol
Remove the spark plug wire from the spark plug. Use some heavy gloves or a set of insulated pliers to hold the spark plug wire about 1/4-inch from the engine block (ground) and crank the engine - you should see a spark jump from the wire to the engine ground. For a better check, use another spark plug and put it on the spark plug wire and use it as a "jumper" from the wire to the engine ground.
You probably have a loose wire and when you put it in gear the engine tilts and comes in contact with your loose wire
Chevy moved it from the frame rail and put it inside of the fuel tank in 2004
Yes
You need a copper wire and magnets. put magnet on plus side of battery and then form the copper wire around it.
It normally bolted to the back of the head, You can put it anywhere on the engine if you want as long as it is hooked to the engine
take it to the shop to put on the computer
To strip wire, you can use a wire stripper tool by adjusting it to the appropriate gauge of the wire, then placing the wire inside the tool and squeezing the handles to cut through the insulation. Another method is to use a utility knife to carefully cut around the insulation and then pull it off. Always be careful not to cut into the actual wire while stripping.
It is on because u did not put the cap back on tight enough.