answersLogoWhite

0


Best Answer
Answer

Hi, The port where the OBD or instrument where the garage or tech needs to hook up to is located to the right of the steering column down near the left side of the console. That's the only way I know of that a '97 can be reset, I have a '97 and have had to go through this a few times and have seen it done. I'm not willing to buy a code reader yet. Hope this helps and good luck. Steve H.

buzzzzz, close.

its an OBD2 car and all code readers and scanners can do this task.

as will pulling the DOME fuse , reset it.

but if something is wrong and you power reset it you loose the DTC.

Diagnostic trouble codes,

so go to any auto store as say, lplease mister , pull me CEL codes.

free.


or buy a code reader $26 + free shiipping from fleebay.

have family members chip in lousy $5 , and not be helpless.

just 2 trips to AZ pays for the silly reader. (gas saved)

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How about resetting Check Engine light on 97 Geo Tracker Where's that switch?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What can I do if my 1993 Ford Escort won't start and the check engine light and the fuel cut off switch light are both on?

Try resetting the fuel cut off switch and see if the engine will start


Reset fuel switch on a 98 Chevy Tracker 2x4 1.6 liter engine?

reset what? this makes no sense. sorry .


Wheres the loctation for the fuel reset switch for a 1995 s10 Chevy?

It doesn't have a fuel reset switch.


Where or how do you reset the check engine light on 95 Geo Tracker?

on the driver side by the front speaker up underneath is a switch that turns off the check engine light.


Where is the reset switch for check engine light on 1996 Geo Tracker?

There isn't a reset switch. The light is reset with a scan tool after the cause of the trouble code has been repaired.


Trying to find a diagram location for the check engine reset on a 92 Chevy Tracker?

There is a switch behind the left front speaker that resets it.


Where is clutch switch on a Chevy Tracker automatic?

If it is an automatic it will not have a clutch safety switch it will have a neutral safety switch


Will a 2001 ignition switch fit the 2000 Chevy Tracker?

Yes, the 2001 ignition switch for a 2000 Chevrolet Tracker will fit just fine. Other years the switch fits are 1999 to 2004.


Can you switch the engine from your 1990 auto tracker with your 1994 tracker with a stick shift striaght across without any mods?

I don't know about the years in questions, but in regards to a straight swap, the answer is no. Since you are going from Auto to Manual, you also have to swap the tranny.


How do you reset service indicator on2009 jaguar xf?

> Resetting service reminder: 1. Press and hold rear fog lamp switch 2. Turn ignition on, do not start engine 3. Release rear fog lamp switch 4. Press and hold trip button (end of left side stalk) 5. Press and hold rear fog lamp switch 6. See "Resetting Service Light" message in message center


Where to find engine wiring harness that plugs into the neutral safety switch on the transmission of a 1991 tracker automatic 4 wheel drive?

Top of tranny under shift lever.


What is causing sparks in the combo switch when the flasher is used on a Geo Tracker 1994?

There is a short in the switch. Replace it/.