0
I guss the old way spray a little carb cleaner in it and shake it.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Where is PCV valve located on 6.0 L Chevy engine?
04 chevy 6.0 2500hd
How do you tell if a PCV valve is going bad in 04 Ford Freestar?
The easiest way to check this is to pop out the PCV valve. Once it is out, inspect it for dirt or oil, and give it a shake - it should make a rattling sound if things are in working order. It doesn't hurt to change your PCV valve after a period of time just to keep things running well.
Where is the PCV valve on a 2005 Toyota Camry?
On the oil fill cap side of the valve cover. To access the PCV valve you will need to remove the protective plastic cover mounted over the valve cover area.Two small nuts are holding it in place. Unlike other PCV valves you may have changed in the past, this one is screwed into the valve cover instead of being inserted into a rubber grommet. You will need a 22MM deep socket or a suitable wrench to remove it. karjunkie 04/17/10 12:24 pm PST
Where is the PCV valve located on a Chrysler Sebring LX 2.7 Ltr engine?
I have a 04 sebring 2.7 L, the PCV Valve is located on the top of the engine. Towards the back and towards the driver side. There is a wire casing right beside were the adaptor comes out of the top of the engine. From this plastic piece coming out at 90 degrees screws in the PCV valve. The other end is attached to the hose that runs towards the front of the engine. There is only one hose on the top so it should be easy to find..........
When did The Gay Cavalier end?
The Gay Cavalier ended on 1957-10-04.
Where is a PCV valve located on 04 Isuzu axiom engine?
Isuzu pcv number 8-97289-271-0(MSRP $15.95) is located on the left (driver) vavle cover. On the left VC cover it is closest to the rear of the cover towards the firewall. It will have a hose connection on it leading to the throttle body.
Where does the hose connect from the PCV valve on a 2004 Chevrolet Tracker 6 cylinder?
I actually found it after viewing another post. The port is behind the intake manifold above the EGR valve. Very tight space, so feel around back & connect that end first. Then connect the PCV end. Much easier that way. I believe it's the same for 01-04 Trackers V6 2.5L.
What might the problem be if a 1999 Mercury Mountaineer is starting to stall when starting?
Clean the inside of the throtle body where the butterfly is. Also clean the idle speed control which is on the side of the throtle body. Good luck. 11/11/04 - just happened to me. My mechanic is going to; 1) replace EGR valve He also found a leak (with a special leak detecting gadget) at the intake manifold, so that gasket is being replaced. Check your pcv valve, this on thing can cause a lot of troubleshooting. Only 3-5 dollars to buy.
Is a chronic problem with valve cover gaskets in the 2002 Nissan maxima?
Yes, there is a problem with the design of the 2002-2003 valve covers. It's best to replace them with valve cover (rocker cover) for a 2004 maxima. They are exact fit, work better and are MUCH cheaper than the 02-03 valve covers. You must order gaskets seperately and the 04 valve covers come with a new PCV as well.
Can you please tell me where the PCV valve is located on a 2006 handa civic.?
i cant put the pic on here but heres a link to what they should look like http://www.autozone.com/az/cds/en_us/0900823d/80/04/bd/5b/0900823d8004bd5b/repairInfoPages.htm it should be locted somewhere on the valve cover
How do you service a transmission on a 04 cavalier with a sealed for life transmission?
you dont
What the sitting for gy6 150cc valve?
valve adjustment. .03 intake .04 exhaust.
