Want this question answered?
A hose bibb may be known as a spigot or faucet in your area. In any case, it is the valve to which you connect a garden hose.
You have to have a faucet that has threads like you find on the outdoor faucet. Some have them and some don't. If you're trying to attach a hose meant for indoor faucets, you'll have to remove the aerator (the small nozzle on the end of the faucet) so you can screw the hose onto the faucet.
Connect a hose to your faucet and turn it on, put the hose in the water.
Turn hose connection at outside faucet counter-clockwise to disconnect.
If this faucet has a spray hose, turn on the faucet and open the spray hose.This will adjust the diverter in the kitchen faucet to the spray and pressureize the hose.This will allow the faucet to equilize and the sputter will stop if the spray diverter is working. It could be that the diverter part in the faucet is defective.
The term "hose bib" likely originated from the combination of "hose," which refers to a flexible tube used for conveying water, and "bib," which typically refers to a piece of clothing worn to protect the front of the body. Together, "hose bib" describes the outdoor water faucet with a threaded spout used to connect a garden hose for watering purposes.
Get a cap for the connection the spray hose would attach to.
Someone would go to the hardware store to purchase a stripper connector replacement for a garden hose to fix it first. Then he or she would use pliers to connect the stripped connector to a garden hose and then it is fixed.
Water pressure at any point in a household system is the same. ie, if it's 50psi after your PRV, then it will be 50 psi at any faucet (unless that faucet is plugged up)
You can buy an adapter for that in good plumbing stores, about $5.
There is a fitting available that you put on the end of the faucet. Take the screen off the end of the spout and this fitting screws on. It is like a quick connect for an air hose if you are familiar with that.
Siphon it out. You can create a siphon by either sucking really hard on one end of the garden hose while the other end is under water, or the easier way, with 2 garden hoses as follows: -Get 2 garden hoses. Hook one to the spigot, put it in the pool and turn it on. set the other hose up with one end in the pool, and the other wherever you want to drain the water to. -Hold the ends of the 2 hoses that are in the pool, together with your hands, so the spigot water runs through the 2nd hose. Pull them apart, and you will feel the suction pulling the water out of your pool through the empty hose. -Take the hose that is connected to the spigot, out of your pool, and turn the spigot off. -Make sure the other garden hose does not fall out of the pool, or you will lose suction and have to start all over again! -When you get towards the bottom, you will have to physically hold the hose and move it around to get the water out without losing suction. You have to have the end of the hose that the water is running out of below the level of the bottom of the pool. You can do it with on.y one hose. Put one end of the hose in the pool and connect the other end to the faucet and turn it on until the air is forced from the hose. If the faucet is below the pool just disconnect the hose and lay it on the ground. You can move it around as long as the end of the hos estays below the top of the water. If the faucet is above the water level have someone put thier finger over the end of the hose in the pool while you move the end of the hose to a spot below the bottomof the pool.