Want this question answered?
It is important to use stretch vinyl to make seat covers on a motorcycle. To stretch it over the seat, pull the material tightly, and staple it in place.
A vinyl record sleeve
no
Vinyl or plastic based paint.
Latex is more comfortable to wear, and can stretch easier, but people can be allergic to it.
The best way to get vinyl to stretch smoothly is to have a heat source to make it a little more pliable and to get all the wrinkles out. A hairdryer works well, if you have someone available to hold it for you and heat up to spot you're working on.Mark the centers of the edges of the seat cover as well as the centers of the board it will be stapled on.Begin stapling your cover at the center on all four sides. Work your way toward the corners, working in any fullness gradually.Pull down hard on the vinyl as you staple it to make it a snug fit, but be sure to pull it evenly all the way around.http://www.seatcoverset.com/seatcovers-car_seat_cover.htm
Remove the vinyl cover when using a solar blanket to warm the water. If the vinyl cover is used at the same time as the solar blanket, the vinyl cover absorbs most of the heat and then transfers the heat into the air or water between the vinyl cover and the solar blanket. Then the heat transfers to the solar blanket and then, finally, into the water. When this happens, a lot of heat remains in the vinyl cover and air/water between the two covers instead of getting into the water. It is preferable to have the heat absorbed by the solar cover and then transfer directly into the water. Hope this helps... Too much redundancy in pool covers.
Bouncy Castles, Houses, etc. are all made out of a vinyl material. The vinyl material is perfect because it will not stretch, but is strong, durable and tear-resistant.
walmart and hot topic
put tape on it
Depends ENTIRELY on the size of the vinyl squares !
yu lift it up