0
You would use a 1 Phase, 208 input, 120/240 output transformer.
<><><>
No!
This question is really asking how to obtain a 3-phase supply inside a dwelling that currently has only 120/240v single phase. The answer is to ask your electricity supply utility company for a quotation to install all 3 phases onto a new breaker panel. Then, to provide the 3-phase circuit(s) you want to use, you can have appropriate 3-phase breakers, cable runs and outlets installed by any licensed electrician.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
If you do this work yourself, always turn off the power
at the breaker box/fuse panel BEFORE you attempt to do any work
AND
always use an electricians test meter having metal-tipped probes
to insure the circuit is, in fact, de-energized.
Wiki User
∙ 14y ago
Wiki User
∙ 10y agoYour equipment should be labelled on what voltage it works at. If it says 200-250 v that includes 208 v and 240 v. If it says 220/240 v the answer is no but it might work at reduced performance.
Add your answer:
Earn +20 pts
Why there is different types of voltage range 210 Volt 220 Volt 230 Volt 240 Volt 250 Volt in single phase AC system and what it based?
In the US the voltage is about 220 volts. This voltage is based upon the average voltage of the AC sine wave. It can peak as high as 240 volts or as low as 210 volts. So these different voltages are actually referring to an average 220 volt system.
Is a 2000 Honda rebel 250 a 6 or 12 volt system?
12 volts
Do you replace the coil from a 6 volt to a 12 volt when converting from 6 volt to a 12 volt system?
Yes. Since the coil is run at full voltage when starting 12 volts may be too much for a 6 volt ignition coil. It would be at about 8 volts when running. There is a starting resistor.
How can you convert milli volts into volts?
one thousand milli volt= one volt
If a 240 volt system is only drawing 12 volts what is the probably wrong?
Compressor locked
How many batteries can you hook up and still have 12 volts?
You can hook up an infinitive number of 12 volt batteries in a parallel circuit and still have 12 volts.
How do you link 12 volt batteries to get 48 volts?
You must hook them up in series. You will need four 12 volt batteries to do this.
Do you need a voltage regulator if you hook up a 12 volt light to a 24 volt system?
Hook a 12 volt light to a 24 volt system and the light will burn out in seconds. You need a step-down voltage converter to do this.
How do you hook up 2 12 volt batteries to get 24 volt?
Hook then up in Series. Positive to negative. You then have 24 volts but the same amperage of one individual battery.that will short out other battery
Can you hook 2-12 volt batteries and keep 12 volt?
Yes, connect them in Parallel. You will still have 12 volts but the amperage will double which is fine.
How do you hook 2 6 volt batteries together and still maintain 6 volts?
Two 6 volt batteries connected together in parallel will still maintain 6 volts but their amperage capacity will be doubled.
Is France 110 volt or 220 volt?
France uses 220-240 volts for their electrical system.
How many volts are running through a 90 volt system with a 6 ohms resister?
...90 volts...
What Voltage is expected for a 1998 dodge ram?
== == It is a 12 volt system. The alternator should put out 13.5 to 14.5 volts with the engine running.== == It is a 12 volt system. The alternator should put out 13.5 to 14.5 volts with the engine running.
Why there is different types of voltage range 210 Volt 220 Volt 230 Volt 240 Volt 250 Volt in single phase AC system and what it based?
In the US the voltage is about 220 volts. This voltage is based upon the average voltage of the AC sine wave. It can peak as high as 240 volts or as low as 210 volts. So these different voltages are actually referring to an average 220 volt system.
How to wire two 12 volt batteries to equal 12 volts?
You hook them in parallel pos to pos and neg to neg.
Can you operate a 12volt devise from 2 12 volt batteries hooked inseries?
NO. Absolutely not, you must hook them in parallel. Two 12 volt batteries hooked in series will give you 24 volts with the same A/H of one of the batteries. Hook them in parallel and you will still have 12 volts and double the A/H of one of the batteries.
