If a nut is very likely to be tough, or if it's rusted in place, I heat it with a propane torch first. If applying heat is dangerous, I hit one flange of the nut with a spring loaded impact tool.
That's correct. This particular wrench holds the nut or bolt head better than any other wrench.
Because the long handle allows more leverage to be applied to the nut.
A socket wrench can drive sockets that totally encompass a nut or bolt head, thus getting a much better grip of it than a wrench.
A torque wrench tightens with a precise amount of force.
The function of a socket wrench is to tighten or loosen nuts and bolts. It does this better by completely encompassing all sides of the nut.
An anchor nut is a nut designed not to require a wrench for tightening and loosening.
Use a wrench and place it on the large nut. Push the wrench like you are loosening the nut. The tensioner will rotate and remove pressure from your belt.
Do up or undo a nut where a ring wrench or socket might otherwise not fit.
The only reason there is problem in loosening the fuel lines is the wrong wrench is being used, which can slip on the fittings. A flare nut wrench should be used and these are then easy to properly loosen and tighten.
if by "loosen" you mean loosening the belt then just put a wrench on the nut in the center of the pulley and turn it to the left. its basically spring loaded.
A wrench is a tool used to turn a bolt or nut.
A 35mm wrench....
A 14 mm wrench.
A breaker bar is used to loosen very tight nuts. Essentially, a breaker bar is just a very long wrench. The extra length allows the user to provide more torque and get the nut moving. After loosening, a more easily wielded wrench may be used.
An open end wrench.
You can use a crescent wrench, or pipe wrench. Both are adjustable to fit the nut you are working on.
what the hex a wrench? Hex wrench is short for hexagonal wrench, that is a wrench or spanner designed to fit a certain size nut or bolt.