If the aftermarket lights are not a factory option then the lights will need to be drilled into the bumper. Afterwards the lights will also need to be properly spliced into the existed wire harness.
How do you turn off running lights on 2000 Toyota 4runner?"
Order a replacement Toyota 4-runner....!!!
You need to replace the dimmer switch in your gauge cluster. This was caused by a bad ground happens all the time.
Fog lights use special brackets which sit recessed on a 2001 Chevy Cavaliers bumper. To install the fog lights mount the units into the bumper brackets. Then splice the fog lights into the existing wire harness. Use a switch if necessary.
with your hands
1999 Toyota Solara if guages work but not the lights? 1999 Toyota Solara if guages work but not the lights?
The horn is located behind the grill just beside the left and right head lights..
that sounds like i ground in the bake by the lights or if it has a trailer plug i would start their
The dash lights on a 93 Toyota 4Runner are replaced by removing the dash trim and panels. When the dash internals are exposed, the individual bulbs can then be replaced.
To install the fog lights on a 2003 Toyota Camry you must first look inside the booklet and see where the foglights go and how they go on. And however the book says to put them on that is how you should do it.
could be the wiring to the dome light
I've never seen fog lights mounted OEM "in" the bumper on a 1996. However if your talking about on top of the bumper then that is easy. Just unbolt them than take them apart and replace the bulbs. Or do what I did and install newer aftermarket ones, they work much better. With the aftermarket lights you may have to modify the OEM brackets a bit. I used rubber spacers to help hold the new lights in place and cut down the vibration. If your lights are mounted in the bumper, you will have to remove the bumper.