Want this question answered?
It will run anywhere from 60-100 dollars to get a bulb replaced in your projector.
A new Epson PowerLite bulb can cost about $350.
It really depends on the bulb that will be required to replace and the type of projector. Replacement projector lamps/bulbs start around $10 and go upwards to $150.
To replace fog light bulb of Monte Carlo you must remove the entire assembly. Replace the bulb that has been hindered and replace the assembly.
Open the hatch door and locate the two screws holding the tail light assembly and pull the assembly out of the housing. Unscrew the cover assembly, remove and replace the bulb. Reinsert assembly and replace screws
i am guessing that you want to change the bulb and not the assembly. to remove the bulb just turn it to the left remove the old bulb replace in the assembly but this time turn it to the right.
Are you asking how to replace the entire headlight assembly -OR- how to replace just the headlight bulb? Just the bulb.
the headlight assembly needs to come out in order to replace the bulb.
The light assembly is secured with two Phillips (cross-head) screws. Remove the screws, then pry the light assembly from the car. Gently flex the sides of the bulb holder to free the bulb. Replace bulb. Push assembly back into place replace the two screws
1) open the hood. 2) Carefully remove the three screws holding the headlight assembly in place. In my case the screws were black. Be careful as they are screwed into plastic. 3) Carefully slide the headlight assembly out. At this point you can replace the headlight bulb, turn signal bulb, or the entire headlight assembly. To replace the headlight bulb turn the collar holding the bulb in counter clockwise. Pull the bulb out of the headlight assembly. Replace the bulb. Insert the bulb into the headlight assembly insert the collar and turn clockwise until it locks. 4) Carefully insert the headlight assembly back into place. 5) Replace the three screws removed in step 2 being carefull not to over tighten.
To replace the headlight bulb in an S type Jaguar, you will first have to remove the plastic cover across the top of the assembly. After moving the turn signal bulb assembly out of the way, you then remove the second plastic cover from behind the assembly and replace the bulb from there.
Projectors are headlamp assemblies, not bulb types. If you're going to HIDs, it's recommended that you use a projector assembly, as they emit about three times the amount of light the factory halogen assembly is intended to handle.