vas deferens
The case is on the driver's side of the engine bay, near the headlight, it has metal clip you have to pop off and the cover can be removed giving you access to the filter. Replace filter and reintall filter, clips pop back on.
Open the trunk lid, pop the the clips out of the backing carpet, undo the two nuts which are 8mm and pop out the white plastic clip on the indicator side with a pair of pliers. The brake light should be accessible once you have done this.
Once you get the window handle taken off (clip on the shaft between the handle nd the door panel) that will free that section up. The door handle assembly comes off by clips on the outer part of the assembly. The part that the door handle sticks out from is seperate. Once u get that ring off you should be able to pop all the door panel off (after you pop the clips around the whole apnel)
There are quick connect clips on that fitting. simple use a screw driver to press up on the side of the clip and you should be able to remove it. then the lines just pop out.
You need to removed the boot inner panel pop out the plastic clips with a screew driver (smaller part of the clip first) then der is 2 10mm nuts holding it up from the inside
hey dude when you pop your hood, there will be a black box with clips on it, which is connected to your air intake. All you do is open up the clips, and ur old filter just slides out, put the new one in, and clip the clips back on. (at the start putting the new air filter may seem like it wont fit but all you have to do is fiddle it around and it will slide in). hope this helped
there are clips that hold it in so you have to get a spot that you can pop out the clips than undo the rest
wack a mole
you're not getting it seated all the way. the clip has to snap onto the top of the spark plug.
Only video clips i think
first its easy er i think to start underneath the cooling lines are held in by quick connect fittings use an small screwdriver almost as small as one used on glasses pry out on the retaining clips clean dirt if necessary to see clips don't break the clip use needle-nose grab and pull of evenly revers to install but dont force clip on it must be lined up and it will just pop in
remove rubber glove off back of light fitting pop out clip change bulb and put back together you will need needle pliers to pop out clip.