Chevy Venture
Toyota SR5
Height

How can you raise the ride height for a 4 cylinder 1992 4x2 extra cab?

484950

Top Answer
User Avatar
Wiki User
2008-12-19 08:50:58
2008-12-19 08:50:58

you can raise the torsion bars in the front and put blocks in the back is the cheapest way out put in a body lift $100-150 for a kit plus a weekend

but this can cause other issues with the radiator, shifter, and gas tank

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

it is the cylinder closest to the battery.

User Avatar

A 1992 Jeep Wrangler with the 4-cylinder takes 4 quarts, and the 6-cylinder takes 6 quarts.

User Avatar

Larry King TNT Extra 3 - 1992 TV was released on: USA: 22 July 1992

User Avatar

First cylinder in front on drivers side.

User Avatar

On a 1992 Acura Vigor idle is adjusted through a idle control valve. Tightening the valve well raise the lower the idle and loosening it will raise it.

User Avatar

Four cylinder it is on the rear of the engine. Six cylinder it is on the front of the engine.Four cylinder it is on the rear of the engine. Six cylinder it is on the front of the engine.

User Avatar

If a 1992 Jaguar XJS stops working, you can still raise the top. However, this can depend on what is broken. If the battery is dead, then you wouldn't be able to do this.

User Avatar

how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder

User Avatar

It will be located next to the flywheel which is by where the engine and tranny meet.

User Avatar

if it is a 4 cylinder the number one is the first cylinder behind the belts and all that stuff. If it is a v6 the number 1 cylinder is the first cylinder behind the belts on the bank closest to the front of the car.

User Avatar

the tube going into the engine where it says OHC 2.0 in the back

User Avatar

4 cylinder firing order is 1-3-4-2...

User Avatar

There was a 2.9 L - V6 engine available in the Ford Ranger from 1986 to 1992

User Avatar

Four cylinder is 15 psi. Six cylinder is 40 psi.

User Avatar

Where is the thermostat located and how do you replace it on 1992 toyota camry 4 cylinder ingine

User Avatar

2.3 liter ( 140 cubic inch ) SOHC 4 cylinder

User Avatar

The 1992 Mustang LX 2.3 liter, 4 cylinder engine had an increase of horsepower to 105 due to two sparkplugs per cylinder. The V8 model had a rated horsepower of 225.

User Avatar

YES, The 1992 Jeep Wrangler 2.5 liter engine (4 Cylinder) Does have a timing chain. I just finished a rebuild of My 2.5 and it does in fact have a Chain.

User Avatar

The cylinder firing order for the 1992 Acura Integra is: 1-3-4-2

User Avatar

from a 1992 what please? in regards to your serpentine, the engine should, if your lucky have a diagram of how it goes.

User Avatar

4 cylinder is 2.6 ,6 cylinder is 3.0It usually says 3.0 somewhere on the body if it is.

User Avatar

depending on if it has a v-6 or a 4 cylinder. Most were manufactured with a 22R Engine (4 cylinder)


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.