how do you replace rear door lock assembly on 92 pONTIAC tRANSPORT
where is the ignition control module on a 1995 Pontiac Transport and how do i replace it
how do you change a brake booster valve to a 1998 Pontiac transport
how do you replace a blend air door assembly on a 2000 pontiac bonneville
remove wheel, caliper,brakes,rotor. unplug abs connector and unbolt hub. install is reverse.
With a wrench.
With a Hammer
The only part that is needed to replace your 1997 Pontiac rear brakes is a break assembly kit. The brake assembly kit will have everything you need.
You will have to replace the regulator assembly.
most likely you will have to replace the hub bearing assembly autozone for about $80
OPEN THE REAR HATCH DOOR REMOVE THE 2 BLACK SCREWSHOLDING THE BLACK PLASTIC HOUSING OF THE LAMP ASSEMBLY REMOVE THE HOUSING SWING OUT THE LAMP ASSEMBLY TO EXPOSE THE BACK OF IT TWIST THE BURNED OUT BULB HOLDER REPLACE BULB REINSTALL BUD
Driver Side Window Regulator Assembly replace on 2004 pontiac grand prix
By taking it to a GM certified auto technician.
Try a glass shop
Hi,I asked the same question for my 3.8 liters Pontiac Transport 1994, and was told at the concessionnary garage that there is no PCV valve to replace on my engine....that answer from the garage manager and parts dept. people.Pacman
Looking at the headlight assembly, on the side of the burnt out directional bulb, look at the back of the headlight. To the side of the headlight adjusters, on the side wall of the wheel well you will see a 10 mm nut. That nut is the only thing holding the directional assembly on. Take that nut off and jiggle the assembly. It will pull out to the side. Replace bulb and reinsert the assembly. Be carefull that you get the plastic bayonet shaft into the correct hole along with the stud that has the nut on it. tata G
manifold gaskets only need to be replace if they leak, or if the manifold has been removed for some reason
OK ... Here's the REAL answer: You cannot change the bearings on a Pontiac Sunfire. You must replace the "Hub-Assembly" they will be the same on both sides .
It is on the accelerator pedal. You have to replace the whole pedal assembly
Remove carpet inside trunk that covers tail ligh assembly, then unbolt tail light assembly, remove the assembly and bulb fixture of the bulb you want to replace, replace bulb and re-install in reverse order.
unbolt lens, remove bulb socket quarter turn
You have to replace the distributor assembly.You have to replace the distributor assembly.
It is inside the fuel tank. You have to remove the entire tank to replace it. I just did mine and it cost $1350!
There is 2 large plastic screws that hold the headlight assembly`s in. Simply unscrew them and lift the headlight assemblies out then unhook take the bulbs out.