Want this question answered?
after replacing the stearing colum what would cause it not to start. You may have disconnected the ignition switch.
take the plastics off and drill the key slot
Using the ignition key, lock and unlock the drivers door. This resets the car alarm which disables the ignition. The car will now start.
car starts without key
The CE light should come on when you turn on the ignition without trying to start the engine. If it does not, then more than likely the bulb is burned out or is disconnected.
Remote start system
you have a short or disconnected wire in the switch. you may need to replace your ignition switch. i have a 89 jeep and it was doin the same thing: it was the ignition module If one of the wires gets disconnected from the ballast resistor it will do the same thing.
It depends upon what state you live in. In Michigan, you can drive a moped at 14 years old.
The ignition lock seems to be broken.
Pull the Ignition cylinder out of switch. Start with a srew driver.
Unless the moped has some sort of remote start like some cars have, the only way to start a moped without the key is to hotwire it. General hot wiring methods work, though be careful, as this is usually extremely suspicious.
If it is getting fuel, try a new spark plug. The old plug could be fouled.You start by determining the reason why it won't start. Ignition, compression, and fuel... you need all of them in order to get the vehicle running.