Very. not a diy job
On the automatic trans, you will have to remove the pan to drain.On the automatic trans, you will have to remove the pan to drain.
You have to remove the fuel tank.You have to remove the fuel tank.
Remove the reservoir, remove the old pump and install the new one.
On a 1996 Plymouth Breeze, the crankshaft sensor can be found above the oil filter. It should be accessible without having to remove any other parts.
You must remove the timing belt to get to water pump.
You have to remove the drive side tire and the wheel cover to get to the battery.
Push up on it turn ninety degrees and pull.
Disconnect - battery terminal Raise and support vehicle Remove wiring harness from starter Remove mounting bolts Drop starter
OIL PAN REMOVAL Drain engine oil. Support Engine Remove transmission bending bracket. Remove front engine mount and bracket. Remove transmission inspection cover. If equipped with air conditioning remove oil filter and adaptor. Remove oil pan bolts. Remove oil pan. Note: If the exaust blocks oil pan removal, you'll need to loosen it at the manifold also.
Remove wheels Remove caliper mounting bolts Slide caliper off rotor rotor should slide off
Remove the left front wheel and inside fender skirt. The rest becomes obvious.
You have to drain/remove the "transmission" oil pan to get access to the filter.