0
The shaft is either "keyed" or splined to turn the wheel. There is probably just a nut or bolt keeping it on the shaft. Just loosen it up and hopefully the factory put some grease on the shaft so the wheel didn't rust to the shaft and it should just slide off. If it won't come off then LIGHTLY (ask me how i know) tap the inside of the wheel and see if it will slide off. If not then there might be a couple of holes in the wheel for a wheel puller. If not you'll have take it in and have a shop remove it.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How are the rear wheels removed on a lawn tractor?
Either a nut on the axle or with a C clip against the outside hub of the wheel.
How do you remove a retaining ring off the rear wheel of a lawn tractor?
The retainig ring has "tabs" that protrude above the groove where the ring fits. You may be able to grasp one or both tabs with needle-nosed pliers and remove the ring.
How do you remove the plastic hub cap to the rear wheel of a Murray lawn tractor?
I use a flathead screwdriver... but they make a tool. I would guess you could rent the tool from a sears or a Lowes.. but hey, if you have a lawnmower, i bet you have a screwdriver.
Replace rear wheel bearing on 2002 Mercury Mountaineer?
Remove the rear tire and wheel. Remove the axle end cap. Remove the rear wheel seal. Remove the rear wheel bearing. Reverse the process to install the new wheel bearing.
What is a MFWD tractor?
A "mechanical front wheel drive" tractor has front-wheel-assist which means that not only the rear drive wheels pull the tractor ahead, but the front wheels also pull the tractor.
How do I remove a rear wheel bearing on a VQ Statesman?
Begin by removing the rear tire and wheel. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
Where is the fuel pump located on a John Deere 318 lawn tractor?
Right side of engine on rear
Where is serial number located on john deere lawn tractor?
The serial number will be located either above the left-rear wheel or behind the right front wheel on the chassis. You will see a bar-coded sticker with a number below/above it. That is the serial number.
How do you replace rear wheel bearing on a Ford Fiesta 2003?
Remove the rear tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
Remove riding lawn mower rear wheel?
most of them are , one bolt and a snap ring holding the tire so you need some snap ring pliers
How do you replace a rear wheel bearing on a 1997 Mercury Cougar?
You will need to remove the rear tire and wheel. Remove the axle end cap. Remove the wheel bearing nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearing.
How do you remove a tire from a 2000 Harley Davidson?
loosen up the rear axle nut and loosen up the axle adjusters so the rear wheel moves forward, Now remove rear brake caliper from rear brake caliper mount and the remove rear axle and lower rear wheel and slide belt off rear pully. and remove the rear wheel. http://www.ronincycleparts.com
