answersLogoWhite

0


Best Answer

By 'shoes', I assume you mean the rear drum brake assembly. Start by doing one side at a time. This way you have the other side to compare to, noting where all the springs and connectors go. There will be springs on the top arm that need to come off, with two brake tools for drum brakes. One removes springs, the other removes the side springs. As long as you have the other side to compare to, you can't get lost. Make note of which way the adjusters go, very important. Don't blow off the brake dust and dirt etc, spray it with brake cleaner and recover the fluid. Sand down the outer edge of the drum to eliminate the rust ridge. Then after brake assembly is fitted, fit drum to barely snug tight. Put drum on and turn brake asembly to see fitment. Keep putting drum on and off and screw the adjuster out until the drum feels barely snug on the assembly.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do I go about replacing brake shoes for a 1999 Ford Ranger 2 wheel drive?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What size rear brake shoes does a 2003 ford ranger have?

Either 9 inch or 10 inch brake shoes


How do you replace the rear brake shoes on an 1989 Ford Ranger?

Take it to a garage and ask them "Can you replace my brake shoes please"


What causes Grinding sound from rear of car when you brake?

brake shoes or pads are worn and need replacing


How to check the emergency brake on a 1995 ford ranger?

a simple test you could do would be, put your vehicle on drive then apply the emergency brake and let go the brake pedal. if the emergency brake is good your car shouldn't move at all.ifbrake shoes. it moves it may be your e-brake or worn


How do you replace the brake cylinder on a 1996 Ford Ranger?

Master cylinder or drum brake (hydraulic slave) wheel cylinder or disc brake caliper cylinder? drum brake shoes rear


What size rear brake shoes does a 1999 Ford Ranger have?

You could have either 9 inch or 10 inch , depending on the brake drum size


How will a car drive with weak drum brake return springs?

The car will drive fine but the rear brake shoes may drag on the drum. This will quickly wear out the rear brake shoes, hurt you fuel mileage, and cause a loss of power. Replace the springs.


How do you go about replacing the drum brakes?

When replacing drum brakes, you will need the following tools; New brake shoes, Brake springs, Pliers, Jack stands, Wrenches, Brake retainer tool, Screwdriver, Pry bar, Hammer, White lithium grease, Dust mask, Car lift, Brake clean and Anti-seize. First you have to find out if your car is a front of rear wheel drive, when you figure that out, you will have to drain the master cylinder brake fluid out. Remove the tires and remove the wheel bearings. Once all the components are off you can replace the brake drum.


How do you change rear brake shoes a lancer?

Remove the tire and wheel from your Mitsubishi. Remove the brake spring and the brake caliper. The brake shoes will come off. Reverse the process to install your new brake shoes.


How do you fit rear brake shoes to a 1996 frontera 2.8 tdi?

The simplest way to fit rear brake shoes to your 1996 vehicle is to purchase the appropriate brake shoes. The appropriate brake shoes will automatically fit perfectly.


How long would a leaking slave cylinder last on a F 150?

a leaking slave cylander is already useless. it nneds to be rebuilt with a kit straight away or completely replaced. a leaking slave cylander can cause loss of brakes in an emergency also while this is leaking , the fluid will soak into brake shoes or pads making them about useless. you may be able to remove most fluid from brake shoes with boiling water when replacing cylander. but usually u will have to replace brake shoes a leaking slave cylander is already useless. it nneds to be rebuilt with a kit straight away or completely replaced. a leaking slave cylander can cause loss of brakes in an emergency also while this is leaking , the fluid will soak into brake shoes or pads making them about useless. you may be able to remove most fluid from brake shoes with boiling water when replacing cylander. but usually u will have to replace brake shoes


Do I need brake pads or brake shoes for 1998 Chevy Tracker?

do I need brake pads or brake shoes for 1998 Chevy tracker