Want this question answered?
2003 buick century wheel stud size = 12mm x 1.5
If by stud you mean wheel stud you have to remove the bearing and have a shop take it out or rent a press and press it out yourself because wheel studs are pressed onto the wheel bearing.
The hub will need to be removed and the stud pressed or drilled out to be replaced.
Remove wheel, brake caliper, brake disc, parking brake shoes etc. Drive out broken stud, replace with new stud. Replace above in reverse order.
Same way you remove any wheel stud. Hammer and appropriate punch. Sometimes a good solvent for the really difficult ones!
if it has the same stud pattern yes. hope this helpsYes, as long as they fit.
Jack up the vehicle and put a safety stand under it. Take the wheel off. With a hammer hit the stud on the tip, several blows should knock it loose. The stud can be pulled out from the rear. Slide a new stud into place, and put to two or three washers on it. thread the nut on, then tighten it. The nut will pull the stud in tight. Remove the nut and washers, then remount the wheel.
12mm by 1.5
take off tire, use a hammer to push out the old stud toward the car, slide the new one in and hammer it in do nut hit the new one on the side with the threads, if it has rear wheel drum brakes u will need to take off the drum
You need a press to do it. Most tire shops can replace wheel stud-that's IF drum is worth saving. You will have to take it in.
Did it on a 4Runner at a Firestone Tire Shop. They charged my $15 for the part and $50 Labor. Rear wheel.
remove the wheel then the brake drum then tap out the old studs with a hammer and pull in the new stud with some washers to protect the threads and tightening the nut until the stud is fully home reinstall the drum and the wheel and torque bolts and you are done good luck