0
How do I remove and replace a 1994 Buick Regal power steering pump Do you need to remove water pump first There is a pipe and bracket coming from the water pump that attaches to the bottom of PS pump?
Wiki User
∙ 16y ago
This may help. http://www.autozone.com/az/cds/en_us/0900823d/80/0e/df/40/0900823d800edf40/repairInfoPages.htm
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you Replace Steering wheel fluid?
Remove the plug on the bottom of the power steering fluid pump. Drain the power steering fluid out. Replace the plug to the bottom of the power steering pump. Replace the power steering fluid.
Flasher for fiero?
It's located to the left of the steering column just behind the bottom cover mounted in a bracket.
What bolt on the bottom has to be loosened to change the power steering belt on a 2000 Hyundai Elantra?
To adjust or replace the belt first loosen the pivot bolt (through-bolt) at the bottom of the bracket. Next loosen the adjuster lock bolt and move the pump to allow belt replacement.
How do you replace ignition switch on 96 caprice 9c1?
you have to take the bottom steering column apart.
Will a mid bottom bracket fit into a frame designed to hold an American bottom bracket?
NO!
How do you repair gt i-drive bottom bracket?
Bottom brackets these days are mainly sealed, maintenance-free cartridge units. when they begin to give you trouble simply replace them.
How do you replace the thermostat located on a 1993 Geo Prizm?
On the radiator you have a top hose and a bottom hose. Look at the bottom hose and follow it to where it attaches to the block. Unscrew the two bolts. There is the thermostat.
How do you replace a power steering belt in a 1987 camaro?
There are three bolts holding the power steering pump bracket in place. They all three must be loosened(not removed). Two go into the front of the engine block. You will need a socket with an extension to reach them. The third is on the bottom of the a/c bracket. Can be a little bit tough especially if your car has headers. Loosen the bolts and push the pump towards the passenger side. It should slide enough to take off the belt and replace. Then reverse the procedure with one exception. Tighten the middle bolt last. It pulls a little extra tension on the bracket and helps tighten the belt a little bit more.
How do you replace the parking light bulb in a 2002 Mercury Grand Marquis?
check the bottom of the steering column
How do you remove 1992 Acura Vigor rear seat bottom?
The seats on a 1992 Acura Vigor use bracket which are found underneath and behind them. Loosen the bracket bolts to release the seats Pull them off and replace them.
How do you go about changing the entire steering column in an automatic 1989 Firebird?
steering column removalto replace steering column: take lower cover off, then there is a bracket on the bottom of the column with four brass bolts in it, remove those. on that same bracket there are two metric nuts on either side of the column, remove those. now the column will drop. next remove the ignition switch and dimmer switch. now that u dropped the steering column you will have access to them. go ahead and remove three bolts from where the steering column meets the firewall(you will need to pull the carpet back a little). next pop the hood and locate the steering gear on the drivers sidetowards the front take ou the bolt holding in the shaft to the gearbox. and then the steering column should slip right out.
Can you drop the steering column without taking off the steering wheel to replace ignition switch?
Yes. Just take the U clamp off the bottom of the steering column and it will drop down so you don't need to take off the steering wheel.
