remove the screw that holds the inside handle of the panel then pry the top portion of the panelremove three screws that hold the bottom portion of the panel raise the glass then look inside where the lock goes remove the linckage that operate the lock remove the horse shoe clip that holds the lock and install the new one and reverse the prosiguies....
remove the radiator, then remove 4 screws that holds the fan ,,done..
yes, you have. And change new seal too.
I would advise you to check out the Previa site on yahoo. It is an excellent site. Check this site it out http://tarago.blogspot.com/ , it helped a lot.
remove the radio.and once outside remove the tape deck wich is screw to te radio.
Get a Haynes manual - there's a lot of stuff to take off
look in how to bleed air off cooling system
Remove the engine fuse for 10 seconds and put them back simple
The dashboard on a Toyota Previa is held on with several bolts. All must be removed. After the bolts are removed so must be the remaining clips. The dashboard that has to be carefully removed from the cabin of the vehicle.
Remove the light assy then turn the bulbs countereclockwise to remove the bulbs.
a) car service center b) private car mechanic c) hammer d) shotgun e) locate the battery and remove it
Unless the actual arm is broken, I would just replace the rubber. You can order it from Toyota, and its way cheaper than a whole wipe arm.
lift tailgate and look for two screws and remove them, and then turn the bulb housing right and oull out