0
To take off the interior door panel on Pontiac Montana,
- remove bolt under door pull (10mm).
- Remove plastic "scoop" behind handle and lock with flat screwdriver blade.
- There is another bolt under it. Remove it.
- Pry up plastic housing for lock and window controls with flat blade screw driver.
- Remove wiring ( 3 units - mirror, lock and window controls) from housing
- Pry around entire panel with a large screwdiver or prybar,pulling outnylon screws from holes in sheet metal.
- Lift panel out over handle and lock module, feeding wiring from controls through hole so that panel comes free.
- Then remove clear plastic from inside of panel to access window mechanism.
Now if I just knew how to test window controller or motor to see what's not working.
What else can I help you with?
Cylinder Torque sequence 2000 Pontiac Montana SV6?
What is the Cylinder Torque sequence 2000 Pontiac Montana 3.4V6
Where is vacuum modulator on a 2000 Pontiac Montana?
The 2000 Pontiac Montana does not have a vacuum modulator installed on it. Instead, it has an electronically controlled transaxle.
How do you change freeze plugs in Pontiac Montana?
where is the freeze plug located in a 2000 pontiac montana mini van
Where is the blwrmtrresistor located on a 2000 Pontiac Montana?
above passenger feet. remove cover, reach as far forward as you can, you will see the connectors.
How do you recharge the air conditioner in a 2000 Pontiac Montana?
No
Refrigerant type in 2000 Pontiac Montana?
r134a
How long does a fuel pump for a 2000 Pontiac Montana last?
my 2000 Montana is still on its original fuel pump
Where are the oxygen sensors located in the 2000 Pontiac Montana?
they are located in the exhaust system Where ? how many 02 sensors on a 2003 Pontiac Montana
How do you remove the wiper switch on 2000 Pontiac Montana?
To remove the wiper switch on a 2000 Pontiac Montana, first disconnect the negative battery cable to ensure safety. Then, remove the steering column cover by unscrewing any screws and gently prying it apart. Disconnect the electrical connector from the wiper switch and remove any screws securing the switch to the column. Finally, pull the wiper switch out and replace it as needed.
What size engine is in a 2000 Pontiac Montana?
its a 3.4 liter
Where is ignition switch located on 2000 Pontiac Montana?
On the 2000 Pontiac Montana, the ignition switch is located on the steering column, behind the steering wheel. To access it, you typically need to remove the lower steering column cover. This switch is connected to the ignition lock cylinder, allowing you to start the vehicle when the key is turned.
A Wire came off a spark plug in our 2000 Pontiac Montana and it seems the plug is also broke in there how do you get to the plugs it is now running on 5 cylinders badly do you remove the alternator?
If the spark plug is cracked and will not turn out on a 2000 Pontiac Montana, a person might have to remove the manifold to get at the plug. Removing the alternator can also help but if the plug is stuck, the manifold will have to come off to get the plug out.
