Want this question answered?
how do you remove steering wheel on mercedes 560 SL 1987
You should take out the Mercedes badge out of the steering wheel. Then you should see a screw inside the steering wheel. Take it out and you're done.
The knob under the steering wheel of the 1987 Honda Accord adjusts the height of the steering wheel. The knob will allow the steering wheel to move up or down.
In the steering wheel fluid reservoir, passenger side of engine. Add dextron transmission fluid to it not "steering wheel fluid"
Remove the airbag and steering wheel, remove the torx screws from the steering housing and remove the housing, remove the screws from the signal and wiper switch, and remove the screws above the ignition switch and remove the switch. Replace the switch and replace everything in reverse.Ê
it is under the dash below the steering wheel you have to remove the steering wheel to replace it I have a manual that walks you threw this if you like I could send you the steps via email my email is braddonovan29@yahoo.com
This is for a 1995 F150 with air bag. YMMV Steering Wheel with Air Bag SPECIAL SERVICE TOOL(S) REQUIRED ³ Description ³ Tool Number ³ ³ Steering Wheel Puller ³ T77L-4220-B1 ³ Removal 1. Center front wheels (1007) to the straight-ahead position. 2. WARNING: THE BACKUP POWER SUPPLY MUST BE DISCHARGED BEFORE ANY AIR BAG COMPONENT IS SERVICED. Disconnect battery to starter relay cable (14300) for at least one minute to let the air bag backup power supply discharge. Refer to «Section 14-00». 3. Remove four air bag module retaining nuts from air bag module on back side of steering wheel (3600), and lift module away from steering wheel. 4. Disconnect air bag wire harness connector, and remove module from steering wheel. 5. Disconnect horn/speed control wire harness connector in steering wheel. 6. Remove steering wheel retaining bolt. 7. Install Steering Wheel Puller T77L-4220-B1 and remove steering wheel. Route contact assembly wire harnesses through steering wheel as steering wheel is lifted off shaft.
On the steering wheel
Remove steering wheel disconnect Quick Connects unscrew switch and pull out put back in same way
It requires a SPECIAL tool that you can push the plate down with and then remove the lock ring that's around the steering shaft. There is a spring under the plate, IT MUST BE PUSHED DOWN TO REMOVE LOCK RING.
It is for the tilt steering wheel. Pull it out and you can adjust your steering wheel. Push it back in when it is set at optimum for you
underneath the steering wheel where the fuse box is.