If you're talking about the thing that looks like a cross at the end of your drive shaft, take a look at it. There are some ring clamps inset on the face of each arm. You'll need a pair of needle nose to crimp them off. After you remove those, you'll need a nail set or something hard to place on the face and a hammer or baby sledge. You'll need to hammer that piece out in order to remove the u-joint. When you install the new one, it works in reverse. Hope this helps.
yup.
how do put belt on 1990 ford bronco 5.8
No
how do I replace a fuel pump on a 1993 Ford Bronco 302 5.0 L
The map sensor on a 1990 Ford 5.8 EFI Bronco is on the passenger side. It is located on the firewall.
The Bronco 2 was sold between 1984 and 1990. The Ford Bronco 2 was a compact SUV. It was smaller than a full-sized Bronco. It was succeeded by Ford Explorer.
yes
how to replace a thermostat on a bronco 198511
5000 lbs
No, the 351 W was a wider lifter valley and the intake will not interchange
No , the 2.9 liter V6 engine in a 4X4 , 1990 Ford Bronco II is fuel injected
Where can you find instructions for taking apart the hub to replace rotor on ford bronco xlt 1995