Wiki User
∙ 15y agohow to replace a thermostat on a bronco 198511
Wiki User
∙ 15y agoFirst, remove the thermostat housing. Then grab the thermostat by hand and remove it.
To replace the heater core of a 1985 Bronco 2, open the glove box and push on the 2 tabs that hold it in place. After removing the entire glove box, remove the round plastic screws of the heater core. Remove the old and replace with a new one.
It is at the engine end of the upper rad hose. Remove the housing and there it is. When replacing it make sure the spring goes toward the engine/
its located on the passager side of the truck under the dash
Buy a new car to replace the faulty thermostat Follow the top radiator hose to the motor. The thermostat is in the housing that the hose is attached to and held by two bolts. Use a new gasket and sealant on fitting the housing.
Under the water manifold attached the upper radiator hose.
Where is the fuel pump located on a 1985 jeep cherokee
I have an '89 Bronco XLT, it has a 25 gallon tank
23 gallon all Bronco II's are
Look in a removable housing at the engine end of the upper radiator hose
Should be in a removable housing at the engine end of the upper radiator hose
It is under the housing where the upper radiator hose hooks to the engine.