I don't believe you (as an operator) can "reset" the check engine light. A mechanic can probably reset it using the port that actually draws the code which caused the failure. When my check engine light came on, I did what the owners manual indicated and just tried a few more tanks of gas (manual indicated that a bad tank of gas might be the problem, or the gas cap might not be installed correctly). After a tank and a half, light went out and hasn't been back on since.
The check engine light on a Mazda Tribute gives warning of potential problems. It can signal overheating, low oil, or engine misfires.
When the check engine light comes on, it's a good indication that something is wrong with your engine.
On a Mazda tribute, the car with a key light indicator means that the engine is started.
Go to AutoZone and ask one of the fellas to come out and "check your check engine light code". They will be able to tell you what the problem code is, as well as re-set your check engine light.
how to reset check engine light on 1992 Mazda mpv
If the check engine light is blinking , an engine cylinder misfire has been detected
After correcting what the initial problem that caused the light to come on, I was able to disconnect the negative terminal of the battery for about 1-2 minutes and the light went away. I hope this helps... "01" Mazda Tribute 3.0L V6
A flashing check engine light means an engine cylinder misfire has been detected
I'm not sure but you may need to check the engine.
If you have an OBD (On Board Diagnostics) scanner, you can read the error code and reset check engine light. Obviously, if the problem is still occurring the light will come back on. Most of the chain autoparts places will read and reset the OBD for you for free. the scanner read #141
ODO
There is no dedicated fuse for the light.