you have to remove the pull start cover, then the spark plug and block the piston from reaching the top of the cylinder head. Romove the little metal sreen covering the fly wheel and use a pipe wrench to remove the metel part in front of the fly wheel. My fly wheel slid off pretty easy but it might take some work to get it off(dont drop the key) once the fly wheel is off you will have a metel cover over the points and condenser. Remove that and you will have access to them, ive never replaced them but i have worked on them. I would suggest cleaning and making sure the gap is correct before replacing, make sure not to get any of your oil from your hands on the point or condensor.
GOOD LUCK
How do I change points to electronic ignition on a 5 hp briggs & stratton small engine?
If they are bad, then yes. If not, then don't bother replacing them.
you can goto briggsandstratton.com and get a manual for that engine,
0.030 is the gap for briggs and stratton 4.5 hp mower
were can i find a wiring diagram for a 18 hp briggs and stratton engine
You can get that info on the Briggs and Stratton website. Just go to: http://www.ereplacementparts.com/briggs-and-stratton-parts-c-16758.html?gclid=CPCZj4vGr58CFZdM5Qodp3bDsA and enter your engine model number.
Where is the location of the idle screw on the Briggs and Stratton 6.0 engine mulcher mower?
Kohler for sure
The 15.5 Briggs does not have an oil filter.
If the first two digits of the engine's model number are the same, the answer is yes.
Briggs & Stratton part # 491056 NAPA filter # 1348
what plug size fits a 3.75 briggs and stratton,and a 19.5 briggs engine and what is the gap. thank you