pop up centre consul plastic around gear shift, undo 2 screws under ashtray, remove the 2 screws from either side of the centre consul (you may need to move the seats back to access the screws). remove the two screws to the rear of the gear shift joining centre consul to rear part of centre consul. pop of the covers in either side of the footwell. undo the screws which are now visable. pull out the centre piece of the centre consul/dash from the bottom, slowly as not to break any clips, the whole centre piece will lift off, remove wiring plugs from connectors. this should now leave the sat nav/ CD accesible, undo the four screws holding these in place and remove DVD player and CD player together, once out remove the screws from either side and the DVD player will slide out.
hope this helps. Alot easier to understand when the bits are in front of you.
Martin.
Jack the front of your car up and put it on axle stands, drain the oil, then undo all the bolts around the top of the sump.
Somewhere around the gearbox in the engine bay.
Undo the screws around the number plate, take the number plate off then put the new number plate on.
get a slege hammer and smash it to bits
In order to change the front wheel bearing on a Nissan X-Trail, one must remove the hubcap from the tire, thusly remove the tire from the car's axel, and then feel around for the wheel bearing and dislocate it.
ittle to get at the bolts that hold down the retaining pa=late around the boot.
Undo the 2 screws at the bottom of the of the panel then pull the panel out by the 2 heater vents at the top, when its out there should be 4-6 screws around the radio, undo them all then pull the radio out slowly until you can disconnect the wires at the back.
remove plastic moulding around door handle and door lock. unscrew door handle and unsnap plastic anchors around lower portion of door unscrew door panel from door. lift up on panel and remove. remove plastic. unscrew motor from door , let window down and remove two screws holding window. remove motor and metal bar replace and reverse process. 1991 Nissan maxima
Just buy a rebuilt starter from Auto Zone. They're around $100.
Pull the shifter bezel out near the ash tray, and carefully pop the bezel out from around the stereo. The 4 screws around the stereo will remove it.
you have to remove the front console. take out the ash trey. and remove all the screws around the trim of the area of the stereo and then slid the stereo out and un hook all connections. if you get a new stereo it should have more detailed instructions
The molding around the dash area where the stereo has several hidden screws up under the cross pieces. Remove those and it should pop off. From there the stereo has 4 screws that hold it in place.