you have to remove the front console. take out the ash trey. and remove all the screws around the trim of the area of the stereo and then slid the stereo out and un hook all connections. if you get a new stereo it should have more detailed instructions
put the parking brake in, then put the truck in 1st gear pop the dash cover off and then remove bolts from stereo.
Begin by removing the decorative stereo retaining cover from your 1999 Ford F2 50 pickup truck stereo. Remove the stereo retaining screws. The stereo will slide out. Remove the wiring harness and the antenna cable from the back of the stereo.
FIRST YOU HAVE TO REMOVE THE FACE OF YOUR dash IT JUST POPS OFF... THEN U CAN SEE THE RADIO JUST UNSCREW THEN PULL OUT THEN UNPLUG WIRE HARNESS.
I remove my stereo from my GMC Truck and now my lights don't work
remove s.w.cover ,remove bolt,use s. w.remover
u have to go to the shop and buy it and pay the shop to install it
How to remove the factory radio and disconnect wirring harnes in a 2004 f150 ford truck
To hook up stereo speakers in a truck, attach the stereo wiring to the stereo and run it to the speakers. Clip the stereo speakers into the wires and place them in the panel spaces in the truck.
tucked under the truck mat near the wheel wells
Yes you can remove it and still drive the truck......
to start off you have to pull off the dash trim around the raideo and the dash. once you do that their are 2 clips one on each side of the raideo you just push them down and pull and out comes the raideo.
no sir