http://www.ehow.com/how_2277150_diy-fuel-injection-ecu-controller.html
no need for map sensor enhancers on cars before 1996...
There is no such thing as a MAP enhancer. If you have this throw it out or get your money back as it will do nothing for the car but decrease mpg while not doing anything for performance
www. motorcraft. com ( no spaces ) does not list a MAP sensor for the 5.0 L (302 )
You had best not go there unless you are ABSOLUTELY positive of what you are doing. A wrong move can and will cost you a small fortune.
It uses a MAP sensor.It uses a MAP sensor.
a map sensor is a manifold absolute pressure sensor.
if it has a 3.3 there is no map sensor
map sensor
That year did not have a MAP sensor.
This is to enhance change in the maps texture. It is often used as a texture enhancer, or it's just for show!
there is no map sensor on it
What if your maf sensor doesn't have a wire like this (frequency type)?* If your maf sensor doesn't have a wire with this varying voltage signal, then you have a frequency based sensor.* You will have probably two wires with a negative ground signal running through them. That's the wires to focus on. One of these ground wires will be the one to hook the enhancer up to.* We found the correct ground wire to enhance through trial and error. There were only two wires with a negative- signal to test.* When the enhancer was installed on the correct negative wire, the vehicle responded to the mpg max enhancer just like any voltage type map sensor would.* You should be able to make the engine shut off at will by adjusting unit to a full lean condition.