0
Depending on which sensor, IS it sensor 1 or 2
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you change an oxygen sensor in a 1995 Honda Civic LX?
Unplug it and unscrew it.
How do you fix an oxygen sensor on a 2000 Honda civic?
The only thing you can do to them is change them.
How do you change the oxygen sensor on a 1999 Honda Accord EX?
Answer There are two o2 sensors, one on the intake manifold and the other on the catalytic converter.where is the oxygen sensor located on 99 Honda accord
Where is the oxygen sensor in a 1992 Honda Prelude and how do you change it?
Oxygen sensor or lambda sensor is situated in the exhaust pipe in front of the catalyst. Disconnect from loom and unscrew with large spanner.
How do you replace oxygen sensor in Honda Odyssey?
To replace the oxygen sensor on a Honda Odyssey, first unscrew the sensor. Then use a 22 mm socket or 7/8 inch wrench to replace the oxygen sensor.
Where is Honda City oxygen sensor located?
Oxygen sensor is located at the exhuast Manifold.
Where is the bank 1 sensor 1 oxygen sensor located on a 2002 Honda Accord?
The bank 1 sensor 1 oxygen sensor on a 2002 Honda Accord is located on the header. It is right next to the sensor circuit.
Where is the oxygen sensor located on a 1987 Honda Accord?
Honda oxygen sensor is usually positioned in the exhaust manifold downpipe before the catalytic converter of your Honda vehicle or in the middle of the two mentioned components. For more details: http://sites.google.com/site/hondarepairsite/home/2004-honda-oxygen-sensor
What is the best oxygene sensor for a 1993 Honda Accord ex?
The 1993 oxygen sensor is the best sensor for a 1993 Honda Accord EX.
What is P0154 for v6 Honda Accord 2003?
It is the oxygen sensor.
How do you change the oxygen sensor on a 1990 Honda Prelude?
I,m not sure how to change it, but the brackets that held mine rusted and blew a hole in my exhaust. Hope this helps you locate it.
How do you replace oxygen sensor in Honda civic?
The oxygen sensor on a Honda Civic is replaced by disconnecting the wiring harness and removing the sensor using a socket wrench. Anti-seize paste is applied to the threads, a new sensor is torqued into place, and the wires reconnected.
