unless you have a top spec model , which i doubt, you will only have front speakers in the doors and non in the back doors (even though it may look like you have, because there are little preholed vents for them) so you need to run wires from your head unit, then round the back of the glove box, then along the bottom of the door under the rubber seal bit. hope that kinda helps a bit
jus email me if you need anymore help: nitroooz@hotmail.com
front 16.5cm or 165mm rear 13cm or 130mm and the mirrror tweeters are 22.5mm or 2.25cm.
you should find it on the bulkhead at the rear of the engine compartment.
14 Inch
On my Pug 206 I had speaker terminations for rear speakers but no rear speakers fitted. I simply chocolate blocked each one to extend the speaker wires to the boot of the car. Even if you have rear speakers fitted it should still be possible. I've got a 3dr car, so it was fairly easy. If you have a 5dr you may have to try and remove fittiings to run the wires properly
200Nm
32psi front and rear
30/32 mm
Swarm in Route 206
There's 2 answers to this question! ...and this is because Peugeot redesigned the wipers on 206's built around 2001, so...On older 206's (approx 1998 - 2000)Drivers side* = 19" (480mm)Passenger side* = 26" (660mm)*Note applies to UK spec models onlyOn newer 206's (approx 2001 - 2005)Both drivers & passenger = 22" (555mm)Rear wiper blades are 14" (355mm) however generic blades won't fit on the rear due to the arm design, so you will need to order rear blades specifically for the 206.
You can find it at Route 206.
it's the box attached to the windscreen behind the rear view mirror
30amp fuse is used