Did you replace the flashers? if not, that's the problem. They are located on the right of the fuse box, two round metal things. About the size of a large botle cap. Runs about 6 bucks for both.
Look at the relay for the flashers, that should fix your problem.
equipment must be checked on and off regularly to prevent accidents like fire hazards.
Turn signals just quit working- have replaced flasher- checked all bulbs and fuses, checked all obvious wires, cleaned grounds, replaced the turn signal switch (that was an adventure). At a loss- any help out there? Hazards work fine- all other lights work fine- turn signals dead
Have you checked for the flasher unit for hazards not sure where to find it on a cherokee.
With my xg 300, the radio was turning on and off on it's own. I checked the battery and it was bad. Replaced it. Now it's fine again. Go to auto parts store and have your battery checked just in case. Could also be loose battery cables.
you walk away
Assuming you checked all the bulbs and fuses, it sounds like the signal switch is shot.
Did U checked the turn ligths flasher, switch and wiring?
Have you checked the flasher fuse. Its in the fuse box by the brake pedal. Its the larger round one, you might have knocked it out of place or it has to be replaced. Check it out. When the flasher is on, you can hear a ticking coming from it.
1 sec after its happens.
It needs to be processed to make sure there it is not contaminated plus there is a law that makes everyone's food be processed and checked for health hazards.
try replacing the flasher. there should be two, one for flashers and one for turn signals