Been here before, take off the cover, there is a plate behind the bolt that gets bend around it so it cant loosen itself u need to unbend it from the bolt then use a pneumatic impact gun on the bold, trust me a torque wrench or socket wrench or even an elextric impact gun will not be strong enough.
How do you remove the front sprocket from Honda trx 250r
The chain is size 530, and the stock gearing is 15/45, meaning that the front sprocket has 15 teeth and the rear sprocket has 45 teeth.
14t on front. 40t on back
YOu need to remove both CV joints. after that the shaft on which the front sprocket rides will come out of the front diff. Just hit it back with a rubber mallet and put your new sprocket in place then hit from the other side to run the shaft through the sprocket. Reassemble. The front 'axle' or diff is held in by the chassis metal being bent around it. it is not removable.
If you are asking about the sprocket bolted to the front of the cam, you would need to remove the timing cover and remove the 3 bolts on the front of the sprocket. If you are asking about the gear on the back that drives the distributor, it is integral and cannot be pulled.
17 tooth front, 42 tooth rear, 110 link chain, size 530
break it off.
It depends on whether you are talking about the front sprocket (the one at the pedals, called a chainring) or the sprocket at the rear derailleur. The lowest gear at the front is the smallest sprocket/chainring. The lowest gear at the rear is the largest sprocket. So if you combine the smallest sprocket at the front with the largest sprocket in the rear you have the lowest gear available on your bike.
Take off the chain and then there should be 2 little bolts holding on the sprocket. Remove those and then rotate the sprocket slightly so its teeth line up with the teeth on the output shaft and it will slide right off.
Under the timing belt sprocket, on the front of the crankshaft.Under the timing belt sprocket, on the front of the crankshaft.
To remove the driver's seat on a 2007 Suzuki 800c Intruder you need to remove the headrest and remove the screws. Next, remove the bolts and washer on each side of the front of the driver seat.
Feck off big hammer!